* all specifications are subject to change without notice. designed for rugged excellence introduction features ? high speed air connectivity: wlan interface support up to 300 mbps link speed ? highly security capability: wep/wpa/wpa-psk(tkip,aes)/ wpa2/wpa2-psk(tkip,aes)/802.1x authentication supported ? support x-roaming < 100 ms ? support wireless load balance ? support ap/client/bri dge/ap-client mode ? switch mode supported: daisy chai n support to reduce usage of switch ports ? dual redundant ethern et port support redundant mode (recovery time < 10ms) ? secured management by https ? wireless connecting status monitoring ? event warning by syslog, email, snmp trap, relay and beeper ? 1kv isolation for poe p.d. port of IAP-620+ ? rigid ip-30 housing design ? din-rail and wall-mount enabled IAP-620 / IAP-620+ series are reliable 802.11 a/b/g/n wlan access point with 2 ports lan. it supports 802.1x and mac filters for security control. it can be configured to operate in ap/bridge/repeater/ap-client mode. you are able to configure IAP-620 / IAP-620+ series by web interface via lan port or wlan interface. IAP-620 / IAP-620+ series provide dual ethernet ports in switch mode , so that you can use daisy chain to reduce the usage of ethernet switch ports. in addition, IAP-620+ also provides p.d. feature on eth2 whic h is fully compliant with ieee802.3af poe p.d. specification. therefore, IAP-620 / IAP-620+ series are one of the best communication solutions for wireless applications on the industrial network. IAP-620 / IAP-620+ industrial ieee 802.11 a/b/g/n wireless access point with 2x10/100base-t(x)
* all specifications are subject to change without notice. designed for rugged excellence application in practical operation of wireless access point, windows utility (open-vision) is supported. this utility is very helpful for you to search and configure ip of access point on the indust rial network. in addition, th e wireless access point support various kinds of operation modes include ap/ bridge/repeate r/ap-client mode. IAP-620 / IAP-620+ series also support poe p.d. feature to extend the layout up to 100 meters. you can build up the wireless network easily. various kinds of operation modes
* all specifications are subject to change without notice. designed for rugged excellence specifications oring wlan access point model IAP-620 IAP-620+ physical ports 10/100 base-t(x) ports in rj45 auto mdi/mdix 2 poe p.d. port - present at eth2 fully compliant with ieee 802.3af power device specification over load & short circuit protection isolation voltage: 1000 vdc min. isolation resistance : 10 8 oh ms min wlan interface operating mode ap/bri dge/client/ap-client antenna connector 2 x external reverse sma-type antenna connector radio frequency type ofdm, dsss modulation ieee802.11a/n: ofdm with bpsk, qpsk, 16qam, 64qam ieee802.11b: cck, dqpsk, dbpsk ieee802.11g/n: ofdm with bpsk, qpsk, 16qam, 64qam frequency band america / fcc: 2.412~2.462 ghz (11 channels ) 5.180~5.240 ghz & 5.745~5.825 ghz ( 9 channels ) europe ce / etsi: 2.412~2.472 ghz ( 13 channels ) dimension
* all specifications are subject to change without notice. designed for rugged excellence 5.180~5.240 ghz ( 4 channels ) japan(jp): 2.412~2.484 ghz ( 13 channels ) 5.180~5.240 ghz ( 4 channels ) canada(ca): 2.412~2.462 ghz ( 11 channels ) 5.180~5.825 ghz ( 21 channels ) transmission rate 802.11b: 1/2/5.5/11 mbps 802.11a/g: 6/9/12/18/24/36/48/54 mbps 802.11n(40mhz): up to 300 mbps transmit power 802.11a: 13dbm 1.5dbm 802.11b: 16dbm 1.5dbm 802.11g: 14dbm 1.5dbm 802.11n(2.4g@20mhz): 13dbm 1.5dbm 802.11n(2.4g@40mhz): 12dbm 1.5dbm 802.11n(5g@20mhz): 12dbm 1.5dbm 802.11n(5g@40mhz): 12dbm 1.5dbm receiver sensitivity 802.11a: -68dbm 2dbm@54mbps 802.11b: -82dbm 2dbm@11mbps 802.11g: -68dbm 2dbm@54mbps 802.11n(2.4g@20mhz,mcs15): -64dbm 2dbm 802.11n(2.4g@40mhz,mcs15): -60dbm 2dbm 802.11n(5g@20mhz,mcs15): -64dbm 2dbm 802.11n(5g@40mhz,mcs15): -60dbm 2dbm encryption security wep: (64-bit, 128-bit key supported) wpa/wpa2:802.11i (wep and aes encryption) wpa-psk (256-bit key pre-shared key supported) 802.1x authentication supported tkip encryption wireless security ssid broadcast disable and enable protocol support protocol arp,bootp, dhcp, dns, http, ip , icmp, sntp, tcp, ud p, 802.1x, snmp, stp led indicators power indicator pwr 1(2)(poe) / ready: red on: power is on and booting up. green on: power is on and functioning normally. 10/100base-t(x) rj45 port indicator green for port link/act at 100mbps. amber for port link/act at 10mbps. wlan leds wlan link /act: green: link, orange: poor signal green for wlan strength: 1<25%, 2<50%, 3<75%, 4<100% fault red: ethernet link down or power down fault contact relay relay output to carry capacity of 1a at 24vdc power redundant input power dual dc inputs. 12~48vdc on 6-pin terminal block power consumption (typ.) 6 watts overload current protection present reverse polarity protection present physical characteristic enclosure ip-30
* all specifications are subject to change without notice. designed for rugged excellence dimension (w x d x h) 54.1(w)x106.1(d)x145.4(h) mm (2.13x4.18x5.72 inch.) weight (g) 800 g 804 g environmental storage temperature -40 to 85 o c (-40 to 185 o f) operating temperature -10 to 60 o c (14 to 140 o f) operating humidity 5% to 95% non-condensing regulatory approvals emi fcc part 15, cispr (en55022) class a ems en61000-4-2 (esd), en61000-4-3 (rs), en61000-4-4 (eft), en61000-4-5 (surge), en61000-4-6 (cs), en61000-4-8, en61000-4-11 shock iec60068-2-27 free fall iec60068-2-32 vibration iec60068-2-6 safety en60950-1 mtbf (hours) (mil-hdbk-217f2, gb, gc, 25c ) 352,982 352,594 warranty 3 years
* all specifications are subject to change without notice. designed for rugged excellence ordering information iap- a b 0 c code definition wireless mode 10/100 base-t(x) port number option - 1: 802.11 b/g - 2: 802.11 a - 3: 802.11 a/b/g - 4: 802.11 b/g/n - 5: 802.11 a/n - 6: 802.11 a/b/g/n -"2": 2 ports available model model name description IAP-620_us industrial ieee 802.11 a/b/g/n wireless access point with 2x10/100base-t(x), us band IAP-620_eu industrial ieee 802.11 a/b/g/n wireless access point with 2x10/100base-t(x), eu band IAP-620_jp industrial ieee 802.11 a/b/g/n wireless access point with 2x10/100base-t(x), jp band IAP-620_ca industrial ieee 802.11 a/b/g/n wireless access point with 2x10/100base-t(x), ca band IAP-620+_us industrial ieee 802.11 a/b/g/n wireless access poi nt with 2x10/100base-t(x), 1-port poe p.d., us band IAP-620+_eu industrial ieee 802.11 a/b/g/n wireless access poi nt with 2x10/100base-t(x), 1-port poe p.d., eu band IAP-620+_jp industrial ieee 802.11 a/b/g/n wireless access poi nt with 2x10/100base-t(x), 1-port poe p.d., jp band IAP-620+_ca industrial ieee 802.11 a/b/g/n wireless access poi nt with 2x10/100base-t(x), 1-port poe p.d., ca band packing list optional accessories ? IAP-620/620+ x 1 ? antenna x 2 ? quick installation guide x 1 ? wall-mount kit x 1 ? cd x 1 ? din-rail kit x 1 ? dr-45 series : 45 watts power supply ? dr-120 series : 120 watts power supply ? rf antenna base (magnetic) series ? rf surge protector ? dr-75 series : 75 watts power supply ? wlan rf antenna (omni-directional) series ? rf cable series
|